Breaking hammer manufacturers talk about fragile breaking hammer accessories

The power source of the crushing hammer is the pressure oil provided by the pump station of the 

excavator or loader, which can more effectively clean up the floating stones and the soil in the rock

 gaps during the excavation of the building foundation. The breaker manufacturer will tell you about

 the fragile breaker accessories below.

 When the brazing pin is seriously deformed, it is very difficult to replace it, so after every 100 to 150

 hours of work, the contact surface between the brazing pin and the brazing should be changed so that 

the two contact surfaces of the brazing pin can If the steel drill you use is not a genuine one, we cannot

 guarantee the good working performance of the relevant parts of the breaker. When changing the

 direction of the shaft pin of the steel drill, the contact surface of the shaft pin should be placed on the 

side of the steel drill. When replacing the wearing parts, check the amount of wear of the wearing 

parts, whether there are cracks and abrasions, etc., especially after the shaft pin burrs and surface 

protrusions are worn off, check carefully.

 I hope that you have a new understanding of our products after reading the editor's content. We

 always insist on: keeping customers with a win-win situation and leading customers with personality.

 You serve!